IDA8 Global-Net User Manual
234
© 2017, ATEÏS, member of PAX ProAV Group
and ECS DSP audio matrix System. It allows users to customize the menu items for the control parameters,
master/sub presets of Ateis audio processors. The URC220 contains a color 2" TFT panel, and with the
well designed user interface it gives the user the best experience of using this control console. Two
buttons and one encoders make menu controlling very simple and easy.
The URC220 is powered over IP and easy to integrate with current demands for room controllers like
light, curtains, sound and video control. The full color display is easy to read and has a low-power
consumption to allow for long lines and multiple devices into one system.
3.2.9.1
Control Panel
TFT Panel:
A color 2" TFT panel presents the menu system of URC 220.
IR Receiver:
It receives the control signals of handheld devices for controlling the system.
Back Button:
This button is used for going back to the upper layer of the menu.
Encoder:
Rotate this encoder for select the item of the menu.
Enter Button:
This button is used for going into to the inner layer of the menu.
3.2.9.2
Configuration
Please see the the steps below to setup the URC-200 for controlling the system.
1. Connect the URC220 to Ethernet switch to the audio processor such as IDA8C, ECS, ...etc.
2. Set the IP/Subnet Mask/Gateway in
3. Edit Control Items, see topic
4. Save the configuration into the URC220, see topic
3.2.9.2.1 Edit Control Items
Users allows to configure and control the menu system of URC-200. The menu system is multi-layered, it
the first layer, there are three items: ECS, LAP G2, AMP indicates what device can be controlled by URC-
200. The following steps are the instruction of the building menus.
