IDA8 Global-Net User Manual
444
© 2017, ATEÏS, member of PAX ProAV Group
5.8.2
Message Source Setting
Set the name for each message channel. The Fire Alarm component can be used up to 4 message
channels and 1 Conflict Message channel with custom setting for individual play list. Click [---] Link
button to open the setting window, see the picture as below.
Each of the Fire Alarm Message can be added in more than one Message Group and the name of
[Message Group] can be changed for users' preference. During the message paging, the playlist of
[Message Group] shall be played orderly from top to bottom [Warning > Fire Alarm > MG3].
Priority: Set the priority for Fire Alarm Message. Select the priority order for message output when
more than 1 message needs to be played in the same paging zone simultaneously.
Play Times: Set the play times of Fire Alarm Message (max.100 times or select [Repeat] button for
continuous play).
Note: The play times is based on when all the [Message Group] has finished playing from top to
bottom.
Message Start Impulse Pin: Set the number of Logic Output signal pin when the message starts
paging.
Message Stop Impulse Pin: Set the number of Logic Output signal pin when the message ends
paging.
Message ACK Signal Pin: Set the number of ACK Signal Pin when Fire Alarm component starts
paging with high signal, and will be as low signal when the message ends.
Message Idle Signal Pin: Set the number of Message Idle Signal Pin when each [Message Group]
are in Idle Mode with high signal, and shall be as low signal without Idle Mode.
The following description of functionality included Prev/Normal/Post...etc. and parameters of each
[Message Group] shall be listed below.
