DSP Components
495
© 2017, ATEÏS, member of PAX ProAV Group
Source List
A source list allows to assign the paging source (from 1 to
16 channel). If a zone is under the paging status, the zone
needs to know which paging source comes from.
1. Right click the Network Paging component to open
[Property] window, then click [...] Source List to
oepn [Paging Source List].
2. Click Network Paging component on DSP design
window, and click [Paging Source] button to add/
remove the paging source.
General Settings
Evac: Enable to set the paging source as an
evacuation source. If the Evac source is activated
during paging, the device will show this "LED
GLOBAL EVAC" state on IDA8 front panel. Also, this
activity will be logged.
Security: Tick the checkbox to change into security
type, which the paging function will still function
for the selected audio channel.
Paging Source: Assign the paging source
which have added on the [Paging Source]
window to the corresponded channel.
This Paging Source function needs to be
worked by using Relay on [Relay] tab
together, please refer to Relay function as
below.
Modbus Type: Set the source type for 3rd
party controller using Modbus protocol to
get data from Ateis devices.
Modbus Channel: Set the source channel
information for 3rd party controller using
modbus protocol to get data from Ateis
devices.
Paging Info(Activation): Click to open a
window for further settings as shown in the
picture below.
Paging Info-Activation
o
Modulation: Paging request is recognized/
released if the conditions on [Modulation
Properties] are satisfied.
Modulation Properties
o
Logic Signal: Paging request is established
