DSP Components
443
© 2017, ATEÏS, member of PAX ProAV Group
Terminate: Enable to control the EVAC input signal in order to terminate the Fire Alarm Message.
Conflict: Enable to play the message that is based on the same priority zone when facing the
circumstance of fire alarm messages and other paging messages may be used in the same paging
zones simultaneously. In this way, the message shall be played in the paging zones with the same
priority.
Configuration
The Fire Alarm Message component must be placed the messages to assigned zones via [Network
Paging Component] and also be triggered by [EVAC Input Component]. The above picture shall
provide you the basic wiring configuration of how each component works. There are three types
of mode for EVAC Input: Contact with monitor/Contact without monitor/ Voltage.
Note: Simply make adjustment by clicking the [Evacuation] component if users intend to change
the types of modes.
5.8.1
Logic Signal & Trigger time
Trigger Detect Output Impulse Pin: Set the number of Logic Output Pin for controlling the EVAC Input
Pin of Fire Alarm component. Once the EVAC Input pin has been triggered, the Logic Output will
continue sending a pulse signal for one second.
Trigger Wait To Execute Time: Set the holding time for triggering the Fire Alarm component. After
triggering, it will only be operated after the end of setting time and start paging.
Fire Alarm Start Impulse Pin: Set the number of Logic Output signal pin when the message-paging
starts paging. The Logic Output will continue sending a pulse signal for one second.
Fire Alarm Stop Impulse Pin: Set the number of Logic Output signal pun when message-paging ends
paging. The Logic Output will continue sending a pulse signal for one second.
Fire Alarm ACK Signal Pin: Set the number of ACK Signal Pin when the Fire Alarm component start
paging with high signal. And the signal shall be as low signal when the Fire Alarm component ends.
