Triumph Tiger Explorer XR 2016, Руководство по обслуживанию

Страница: 539 / 750

ABS ECM Internal Error
Fault Code Possible Cause Action
ABS ECM internal error ABS ECM internal error Ensure ABS ECM connector is
secure.
Proceed to pinpoint test 1:
Pinpoint Tests
Test Result Action
1 Measure the air gap of the wheel
speed sensors between the sensor
and the pulser ring:
- Air gap between 0.1 mm to 1.5 mm OK Proceed to test 1
Faulty Rectify the fault and proceed to test 4
2 Check the pulser rings for damage or
contamination by road grime or
ferrous metal filings OK Proceed to test 2
Faulty Clean or replace the ABS pulser ring,
proceed to test 4
3 Check the wheel speed sensors for
correct installation, and the fixings for
correct torque OK Proceed to test 4
Faulty Rectify the fault and proceed to test 4
4 Clear fault code and test ABS to verify
fault cleared OK Action complete - quit test
Fault still present Contact Triumph service
ECM Communication (CAN)
Fault Code Possible Cause Action
CAN fault - lost communication
with engine ECM CAN fault - lost communication
with engine ECM View and note ‘freeze-frame’ data
if available
Disconnect Engine ECM and ABS
ECM connectors and proceed to
pinpoint test 1:
Pinpoint Tests
Test Result Action
1 Check that the engine stop switch is in
the RUN position RUN Proceed to test 2
STOP Turn the engine stop switch to the RUN
position
2 Verify Engine ECM is powered, Turn
on Ignition and measure the voltage
between:
- Engine ECM pin B01 and Engine 10 - 14 V Proceed to test 3
Faulty Check main fuse box, fuse 8. Replace if
blown. Proceed to test 3
Tiger Explorer XR Series
535 of 746
BRAKES