MPH-02, MPB-02, MPD-02
Operating Modes
7-67
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
If the start block of a switch-signal-dependent sequential block is an
absolute or relative positioning block, the drive positions at target position
if the switch signal for block advance is not received. The drive thus only
generates the message "end position reached" after the sequential block
chain is completed. If a switch signal is then applied, the drive will carry
out the sequential block.
v
02
DK000036v01_en.fh7
positioning block
acceptance:
P-0-4060 (bit 0)
t
S-0-0419,
Positioning command
acknowledge
end position reached:
P-0-4061,
Positioning block
status word (bit 4)
P-0-4051,
Positioning block
acknowledgment
P-0-4026,
Positioning block
selection
velocity
profile
02
positioning inputs valid
positioning acknowledgment outputs show negated status
of positioning inputs
after valid block acceptance, positioning acknowledgment outputs
show non-inverted status of positioning inputs
t
R
positioning block 02
S-0-0124,
Standstill
window
positioning block 01
cam 1:
P-0-4057,
Pos. block, input
linked blocks (bit 0)
target position
block 2
Drive HALT (AH):
S-0-0134,
Master control
word (bit 13)
Fig. 7-40:
Example: switch-signal-dependent block advance (behavior with
failure of switch signal)
Note:
According to master communication, positioning block
acceptance takes place by toggling bit 0 in S-0-0346 or by a 0-
1 edge of bit 0 in P-0-4060.
Failure of Switch Signal for
Block Advance
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
