Vicruns 2S-0.4G-B, User Manual

Page: 76 / 300

In the factory default state, P5-13=00000, when the DI port is short-circuited, it is a
valid (logic 1) signal; when the DI port is floating, the DI is an invalid (logic 0) sign-
al; the user can also change the DI port's signal Valid mode, that is, when the DI
port is short-circuited, it is an invalid (logic 0) signal; when the DI port is floating,
the DI is a valid (logic 1) signal. At this time, it is necessary to modify the correspo-
nding bit of P5-13 to 1. , the two function codes correspond to the valid mode setti-
ngs of DI1~DI5 respectively.
The inverter also sets a software filter time (P5-10) for the input signal of the DI
port, which can improve the anti-interference level. For the DI1~DI3 input ports,
the port signal delay function is also provided, which is convenient for some appli-
cations that require delay processing:
T
T
Hardware DI signal Internal DI signal
Figure 4-27 DI delay settings
The functions of the above five DI ports can be defined in the function codes of P5-
00~P5-04, and each DI can be selected from 53 functions according to requirem-
ents. For details, please refer to the detailed description of P5-00~P5-04 function
codes.
In the design of hardware features, only HDI can accept high-frequency pulse sig-
nals. For applications that require high-speed pulse counting, please arrange it on
the HDI port.
4.10 How to use the DO port of the inverter
The control board comes with 2 digital outputs, which are the control board relays
RELAY1 and Y1, of which Y1 is a transistor output, which can drive a 24Vdc low-
voltage signal circuit; the relay output can drive a 50Vac control circuit.
C
h
a
p
te
r
4
Chapter 4 Operation and Display
-75-