Vicruns 2S-0.4G-B, User Manual

Page: 184 / 300

-183-
Chapter 6 Description of Function Codes
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-38 Current running time set value 0.0min
～
6500.0min 0.0min
☆
When the current running timing of P7-36 is valid, and the current running time source selec-
ts 0: P7-38 setting, and the switch output selects No. 27 function, the running time of the inv-
erter reaches the set time, outputs the ON signal, and at the same time converts the freque-
ncy. The device reports that the running time has reached the fault Err39.
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-39 High level timing 0.0s ～ 6000.0s 2.0s
☆
P7-40 low level timing
0.0s
～
6000.0s
2.0s
☆
When the timer input terminal "on" is longer than P7-39, the output of this timer function is tu -
rned on.
When the timer input terminal "disconnect" is longer than P7-40, the output of the timer func -
tion is disconnected.
Fig.6-19 Schematic diagram of timer input and output operation
P7-39
P7-40
P7-39
P7-40
Timing input terminal
Timing output terminal
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-41 Activate the protection function 0
～
1 1
☆
0: Invalid (start terminal command is valid and start directly)
1: Valid
This parameter is used to improve the safety protection factor. If it is set to 1, it has two
effects:
1) The running command exists when the inverter is powered on, the running command must
be removed before the running protection state can be eliminated.
C
h
a
p
te
r
6