Vicruns 2S-0.4G-B, User Manual

Page: 169 / 300

-168-
Chapter 6 Description of Function Codes
Group P6: Output terminal
KD600 series inverters come standard with 2 multi-function analog output terminals, 1 multi-
function digital output terminal, and 2 multi-function relay output terminals.
Function
code
Name
Description
(setting range)
Factory
Default
Change
P6-00
Control board relay RELAY1
output (TA/TB/TC) selection
0
～
45 2
★
P6-01
Control board relay RELAY2
output (RA/RB/RC) selection
0
～
45 1
★
P6-02 Y1 output selection
0
～
45
1
★
The function selection of multi-function output terminal is as follows:
Value Function Description
0 No output The terminal has no function.
1 Inverter is running
Indicates that the inverter is running, and there is an
output frequency (which can be zero), and the ON signal
is output at this time.
2 Fault output (stop) When the inverter fails, output ON signal.
3
Frequency-level
detection FDT1 output
Please refer to the detailed description of function codes
P7-22 and P7-23.
4 Frequency arrives Frequency arrives, see P7-24 for details.
5 Running at zero speed
When the inverter is running and the output frequency is
zero, the ON signal is output.
6
Motor overload pre-
warning
The motor overload protection is judged according to the
early warning threshold, and the ON signal is output after
exceeding the forecast setting value. For details, please
refer to P9-00
～
P9-02.
7
AC drive overload pre-
warning
10S before inverter overload protection occurs, output ON
signal.
8 PLC cycle complete
When simple PLC completes one cycle, the terminal
outputs a pulse signal with width of 250 ms.
9
Accumulative running
time reached
If the accumulative running time of the AC drive exceeds
the time set in F09.16, the terminal becomes ON.
C
h
a
p
te
r
6