Vicruns 2S-0.4G-B, User Manual

Page: 185 / 300

Chapter 6 Description of Function Codes
-184-
2) If the running command still exists when the inverter is reset to fault, the running command
must be removed to eliminate the running protection state.
This prevents the motor from running automatically without knowing it, creating a hazard.
If it is set to 0, and the running command exists when the inverter is powered on, the inverter
will start directly.
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-43
Frequency reaches detection
value 1
0.00Hz
～
P0-14 50.00Hz
☆
P7-44
Frequency detection value 1
arrival width
0.0%
～
100.0% 0.0%
☆
When the output frequency of the inverter is within the range of the positive and negative
detection amplitudes of the detection value 1, the multi-function output terminal will output an
ON signal. Please refer to Figure 6-16 for the DO output action.
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-45 Current reaches detection value 1 0.0%
～
300.0% 100.0%
☆
P7-46
Current detection value 1 arrival
width
0.0%
～
300.0%
0.0%
☆
When the output current of the inverter is within the positive and negative detection width of
the detection value 1, the multi-function output terminal of the inverter outputs the ON signal.
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-49 user password
0
～
65535
0
☆
If P7-49 is set to any non-zero number, the password protection function will take effect. The
next time you enter the menu, you must enter the correct password, otherwise you cannot
view and modify the function parameters, please keep in mind the set user password.
If P7-49 is set to 0, the set user password will be cleared and the password protection funct -
ion will be invalid.
C
h
a
p
te
r
6