Vicruns 2S-0.4G-B, User Manual

Page: 180 / 300

-179-
Chapter 6 Description of Function Codes
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-26 Fan control 0 ~ 1 1
★
0: The fan runs continuously;
1: The fan runs when the inverter is running;
It is used to select the action mode of the cooling fan. When it is selected as 1, the inverter
will run the fan in the running state. If the radiator temperature is higher than 40 degrees in
the stop state, the fan will run. In the stop state, the fan will not work when the radiator is
lower than 40 degrees. run.
When 0 is selected, the fan keeps running after power-on.
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-27 STOP/RESET function 0 ~ 1 0
☆
0: Only valid in keyboard control ；
1: The stop or reset function is valid in all control modes.
Function
code
Name
Description
(setting range)
Factory
Default
Change
P7-28 Quick /JOG key function selection 0 ~ 3 0
★
The Quick/Jog key is a multi-function key, and the function of the Quick/Jog key can be set
through this function code. This key can be used to switch between stop and running.
0: Forward jog
Forward jog (FJOG) is realized through the keyboard Quick/Jog key.
1: Forward and reverse switching
Use the Quick/Jog key to switch the direction of the frequency command. This function is only
valid when the command source is the command channel of the operation panel.
2: Reverse jog
Reverse jog (RJOG) is realized through the keyboard Quick/Jog key.
3: Switch between panel control and remote control (terminal or communication)
Refers to the switching of the command source, that is, the switching between the current co-
mmand source and keyboard control (local operation). If the current command source is key-
board control, the function of this key is invalid.
C
h
a
p
te
r
6