737 MAX Flight Crew Operations Manual
Supplementary Procedures -
Flight Management, Navigation
SP.11.12
MN-FLT-OH-201
Line select the desired intersection (lines 2L–5L) into the scratch pad
and observe the new created waypoint displayed as
FIX/Radial/Distance.
RTE LEGS page ............................................................................. Select
Line select the new created waypoint, displayed in the scratch pad, to
the desired waypoint sequence.
Repeat the above steps to define additional created waypoints as
desired. Correct any ROUTE DISCONTINUITY.
EXEC key ........................................................................................ Push
Observe the MOD RTE LEGS page changes to ACT.
Note:
These created waypoints are stored in the temporary
navigation data base for one flight only.
Entering a Lateral Offset
RTE page ........................................................................................ Select
Observe the OFFSET prompt displayed.
LATERAL OFFSET page .............................................................. Select
Observe dash prompts for OFFSET DIST.
OFFSET DIST..................................................................................Enter
Enter desired offset distance using format Lxx or Rxx for left or right
offset up to 99 nm. Observe dash prompts for START WAYPOINT
and END WAYPOINT.
START/END WAYPOINT ...............................................................Enter
If no start/end waypoint is entered, offset will begin/end at first/last
valid offset leg.
Change SID or Runway
This entire procedure must be accomplished when a SID is used and the
runway or SID is changed. This will prevent the possibility of incorrect
routing or inadequate obstacle clearance.
DEPARTURES page ...................................................................... Select
RUNWAY....................................................................................Reselect
SID ..............................................................................................Reselect
March 1, 2021