Avaya G700, Installing And Upgrading, Page: 700 / 808

Manual upgrade of an existing S8300B and G700 to S8300C with R4.0
700 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
On-site Preparation for the Upgrade
Perform the following tasks before starting the software upgrade on the S8300:
Accessing the S8300
To perform the installation and upgrade procedures you will need to connect your laptop to the
S8300 Services port using a crossover cable. For a direct connection to the S8300 Services
port, your laptop must be properly configured. See
Laptop configuration for direct connection to
the services port on page 42.
You will use SSH and the Maintenance Web Interface to perform the procedures. See the
following:
●
Accessing the server’s command line interface with SSH on page 55
●
Logging in to the S8300 Web Interface from your laptop on page 57
Note:
Note:
Communication Manager has telnet turned off by default. Therefore, telnet is not
available after remastering of the hard drive is complete during an initial server
installation. However, if the customer later chooses to enable telnet, you may be
able to use telnet to access the server’s command line interface.
Removing the administration for the IA770 integration if CWY1
board is used
Note:
Note:
If the S8300 is configured as an LSP, skip to Upgrade the S8300 on page 712.
!
CAUTION:
CAUTION:
Communication Manager Release 4.0 does not support the CWY1 method of
integration of IA770 INTUITY AUDIX Messaging. As a result, if the S8300 Media
Server uses a CWY1 board to integrate the IA770 INTUITY AUDIX application,
you must remove the current switch integration administration now. You will
administer the integration for H.323 after the upgrade.
For instructions on removal of existing CWY1 administration, see Administering Media Servers
to work with IA770 .