Avaya G700, Installing And Upgrading, Page: 769 / 808

Install new firmware on the G700 Media Gateway
Issue 10.2 May 2007 769
4. Type
copy tftp mm-image v <slot #> <filename mm>
<tftp_server_ip_address>
where
<slot #>
is the slot of the specific media module,
<filename mm>
the full-path name of the media module firmware file in a format such as
mm712v58.fdl, and
<tftp_server_ip_address>
is the ip address of the S8300.
Two or three minutes will be required for most upgrades. The VoIP media module upgrade
takes approximately 5 minutes. Screen messages indicate when the transfer is complete.
5. After you have upgraded all the media modules, verify that the new versions are present.
At the MG-???-1(configure)# prompt, type
show mg list_config
The list of software appears.
Show MG list_config
6. In the TYPE column, find the particular media module (v1 through v4), then check the
matching field in the FW VINTAGE column to see if it matches the planning documentation.
Note:
Note:
Slot V1 can contain either a media module or the S8300, which will show as
TYPE ICC
.
7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP
firmware identified in the planning documentation.
8. Type
reset <module #>
where
<module #>
is the number of the G700 in the stack.
9. When the reset is finished, type
show mm
to verify the upgrade.
SLOT TYPE CODE SUFFIX HW VINTAGE FW VINTAGE VOIP FW
---- ------ ----- ------ ---------- ---------- -------
V0 G700 DAF1 A 00 21.25.0(A) 26
V1 ICC S8300 A 00 5 N/A
V2 DCP MM712 A 2 5 N/A
V3 ANA MM711 A 3 16 N/A
V4 DS1 MM710 A 1 8 N/A