Avaya G700, Installing And Upgrading, Page: 593 / 808

Replacing the S8300A
Issue 10.2 May 2007 593
5. If the IP address is available, click Close Window.
6. If the IP address is not available, enter the IP address and click Change.
Note:
Note:
If an Action Cancelled message appears before the success message, refresh
the screen and click Change again.
When the configuration change is complete, the screen displays Successfully configured
ethernet interfaces . Click Close Window .
At this point, the system resets the IP interfaces.
Enabling RAM disk on the media server
To enable RAM disk, perform the following steps:
1. Access the server’s command line interface using an SSH client, like PuTTY, and an IP
address of 192.11.13.6 .
2. At the command line, type
sudo ramdisk -v -f enabled
, and press Enter
.
3. At the command line, type
ramdisk -v -s
and press Enter .
Rebooting the media server
To reboot the media server, perform the following steps:
1. On the Maintenance Web Interface, under Server select Shutdown Server .
2. Select the Delayed Shutdown option. Also, be sure the Restart server after shutdown
checkbox is selected.
3. Click the Shutdown button.
Click OK to confirm.
4. At the command line, type
ramdisk -v -s
and press Enter .
Confirm that the system has enabled RAM disk.
Note:
Note:
It is good practice to close the browser after the reboot and log back in.