Avaya G700, Installing And Upgrading

Page: 745 / 808

Upgrade the G700 firmware
Issue 10.2 May 2007 745
5. Type
set mgp bootimage <bank>
where
<bank>
is the same letter you entered in the previous step.
6. At the MG-???-1(configure)# prompt, type
reset mgp
.
A system prompt asks you to confirm the reset.
7. Select Yes at the dialog box that asks if you want to continue.
The G700 media gateway processor resets. The LEDs on the G700 media gateway and the
media modules flash. These elements each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 media
gateway are on, the reset is complete.
8. When the P330-1(super)# prompt appears, type
session mgp.
9. At the MGP-???-1(super)# prompt, type
configure
.
10. Verify that the download was successful when the prompt returns.
Type
show mg list_config
.
The system displays the list of software.
Example: Show mg list_config
Installing new firmware on the media modules
For upgrades of active media modules, you need to take the media modules out of service
before initiating the upgrade process. To do this, go to a SAT session on the primary controller
and issue a
busyout
command.
Note:
Note:
Skip this busyout procedure if the media modules are not in service; for example
during an initial installation.
To busyout board (for active media modules)
1. Go to a SAT session on the primary controller and enter the command,
busyout board v x
where
x
is the slot number of the media module to be upgraded.
SLOT TYPE CODE SUFFIX HW VINTAGE FW VINTAGE VOIP FW
---- ------ ----- ------ ---------- ---------- -------
V0 G700 DAF1 A 00 230(A) 67
V1 ICC S8300 A 72 00 N/A
V2 DCP MM712 A 2 58 N/A
V3 ANA MM711 A 2 57 N/A
V4 DS1 MM710 A 1 58 N/A