Avaya G700, Installing And Upgrading, Page: 553 / 808

Before going to the customer site
Issue 10.2 May 2007 553
Creating a super-user login, if one does not exist (releases earlier
than Release 4.0)
If a super-user login does not exist, one must be added before you can complete the upgrade.
The customer or remote services should complete the following task.
1. Use the following steps only if you are starting from a software release earlier than Release
4.0:
Note:
Note:
Adding a super-user login with the SAT command line requires a dadmin, init, or
inads login.
Note:
Note:
If you are upgrading an S8300 LSP, create the super-user login on the primary
controller using this procedure. Then, at the LInux command line on the primary
controller, run the
filesync -a <IP_address_of_LSP>
command.
2. At the SAT command line, enter add login.
The Login Administration screen appears.
3. In the Password of Login Making Change field, type your password.
add login Page 1 of x
LOGIN ADMINISTRATION
Password of Login Making Change:
LOGIN BEING ADMINISTERED
Login’s Name:xxxxxxx
Login Type:
Service Level:
Disable Following a Security Violation?
Days to Disable After Inactivity:
Access to INADS Port?
LOGIN’S PASSWORD INFORMATION
Login’s Password:
Reenter Login’s Password:
Password Aging Cycle Length (Days):
LOGOFF NOTIFICATION
Facility Test Call Notification? Acknowledgment Required?
Remote Access Notification? Acknowledgment Required?
ACCESS SECURITY GATEWAY PARAMETERS
Access Security Gateway?