Avaya G700, Installing And Upgrading, Page: 702 / 808

Manual upgrade of an existing S8300B and G700 to S8300C with R4.0
702 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
To clear alarms
1. On the Maintenance Web Interface under Alarms, click Current Alarms .
2. If no alarms are listed, skip the next two steps.
3. If alarms are listed, click Clear All .
4. Resolve any remaining major alarms through the Communication Manager SAT.
To check link status
1. Open a SAT session.
2. Enter
display communication-interface links
.
Note all administered links.
3. Enter
status link number
for each administered link.
4. Enter
list signaling group
.
Note the signaling groups listed by number.
5. For each of the signaling groups listed, enter
status signaling group number
.
Make a note (write down) of any links that are down.
To record all busyouts
1. At the SAT prompt, type display errors and press Enter .
2. Look for type 18 errors and record (write down) any trunks that are busied out — you will
return them to their busy-out state after the upgrade.
To disable scheduled maintenance
Scheduled daily maintenance must not interfere with the upgrade.
1. At the SAT prompt, type
change system-parameters maintenance
and press Enter .
2. If scheduled maintenance is in progress, set the Stop Time field to 1 minute after the
current time.
or,
If scheduled maintenance is not in progress, set the Start Time field to a time after the
upgrade will be completed.
For example, if you start the upgrade at 8:00 P.M. and the upgrade takes 90 minutes, set
the
Start Time field to 21:30.