Avaya G700, Installing And Upgrading, Page: 124 / 808

Installing a new G700 with an S8300 using the Avaya Installation Wizard
124 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
3. For the S8300B circuit pack only, the LED module (above slot V1) must also be removed or
inserted together with the S8300. Do the following:
●
Disengage the LED module and remove it from the G700.
●
Insert both the LED panel and S8300B circuit pack about 1/3 of the way into the guides
(the guides are in slot V1 for the S8300 and above slot V1 for the LED panel).
●
Push both circuit packs (together) back into the guides, gently and firmly, until the front of
each circuit pack aligns with the front of the G700.
For the S8300C circuit pack only, push the S8300 module into the slot V1 guide until the
front of the S8300 module aligns with the front faceplate of the G700.
4. Secure the S8300 faceplate with the thumb screws.
Tighten the thumb screws with a screw driver.
Note:
Note:
Unplug any external Compact Flash drive that might be connected to the S8300
USB ports. The S8300 tries to read any media connected to a USB port. The
S8300 should only read the media on the CD-RW/DVD drive.
5. Power up the G700 by plugging in the power cord.
6. Connect the laptop to the Services port on the faceplate of the S8300.
Installing Communication Manager Software
Note:
Note:
You cannot use the SSH protocol to access the hard drive on an S8300 Media
Server that has never been installed.
Setting telnet parameters
The Microsoft telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press
Enter . The installation program interprets this as two key presses. You
need to correct this before you telnet to the server.
Note:
Note:
This procedure is done entirely on your laptop, not on the S8300.
To set telnet parameters
1. Click Start > Run to open the Run dialog box.
2. Type
telnet
and press Enter to open a Microsoft Telnet session.
3. Type
unset crlf
and press Enter .