Avaya G700, Installing And Upgrading, Page: 255 / 808

Before going to the customer site
Issue 10.2 May 2007 255
4. In the Login’s Name field, type a login name agreed upon with the customer. Alternatively,
a Business Partner may add the dadmin login.
5. In the Login Type field, type customer .
6. In the Service Level field, type super-user .
7. In the Days to Disable After Inactivity field, type 90 .
8. In the Login’s Password field, type a password.
9. In Reenter Login’s Password field, type the password again.
10. In the Password Aging Cycle Length field, type 90, and press Enter .
11. If you are upgrading an LSP such that you created this super-user login on the primary
controller, do the following also on the primary controller.
a. Log in with
telnet
or
ssh
.
b. At the Linux command line, type
filesync -a <IP_address_of_LSP>
, where
<IP_address_of_LSP>
is the IP address of the LSP you are upgrading.
Creating a super-user login, if necessary, for R4.0 or higher
If a super-user login does not exist, you must add at least one before you complete the upgrade.
The easiest way to add a login is with the Maintenance Web pages. Use the following steps only
if you are starting from Release 4.0 software or later:
Note:
Note:
A craft level login can create a super-user login in Release 4.0 or later.
Note:
Note:
If you are installing software for an S8300 LSP, create the super-user login on the
primary controller. Then, at the LInux command line on the primary controller, run
the
filesync -a <IP_address_of_LSP>
command.
To create a login:
1. Ask a customer representative for a login name and password that the customer would like
for the superuser login. If you are a business partner, you can also repeat this procedure to
add the dadmin login.
Note:
Note:
Make sure the customer can change this login, its password, or its permissions
later.