Avaya G700, Installing And Upgrading, Page: 223 / 808

Administer Communication Manager
Issue 10.2 May 2007 223
2. Log in, and open a SAT session (type sat or dsat ).
3. At the SAT prompt, type
reset system 4
The system reboots.
4. After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assigning Node Names and IP Addresses for the LSPs
If the S8300 network configuration includes LSPs, they must be specified on the Node Names
screen.
To assign node names
1. At the S8300 SAT prompt, type
change node-names ip
to open the Node Names
screen.
Example Node Names Screen
2. Enter the name and IP addresses for the LSPs.
3. Press F3 ( Enter ) when complete.
Administering Network Regions
Before assigning an IP network region to a G700, you must define network region on the IP
Network Region form. After a network region is defined, you can assign it to the various network
elements (servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use
the system defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region,
defined as
1 . The procedure below uses 1 for the network region number as an example but the
procedure applies for any network region number from 1 to 250.
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-10-lsp 192.168.1 _.50_ _______________ ___.___.___.___
node-11-lsp 192.168.1 _.51_ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___
__________ ___.___.___. _ _______________ ___.___.___.___