Avaya G700, Installing And Upgrading, Page: 634 / 808

Manual upgrade of an existing S8300B or S8300C and G700 to R4.0
634 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
4. In the Login’s Name field, type a login name agreed upon with the customer. Alternatively,
a Business Partner may add the dadmin login.
5. In the Login Type field, type customer .
6. In the Service Level field, type super-user .
7. In the Days to Disable After Inactivity field, type 90 .
8. In the Login’s Password field, type a password.
9. In Reenter Login’s Password field, type the password again.
10. In the Password Aging Cycle Length field, type 90, and press Enter .
11. If you are upgrading an LSP such that you created this super-user login on the primary
controller, do the following also on the primary controller.
a. Log in with
telnet
or
ssh
.
b. At the Linux command line, type
filesync -a <IP_address_of_LSP>
, where
<IP_address_of_LSP>
is the IP address of the LSP you are upgrading.
Creating a super-user login, if necessary, for R4.0 or higher
If a super-user login does not exist, you must add at least one before you complete the upgrade.
The easiest way to add a login is with the Maintenance Web pages. Use the following steps only
if you are starting from Release 4.0 software or later:
Note:
Note:
A craft level login can create a super-user login in Release 4.0 or later.
Note:
Note:
If you are installing software for an S8300 LSP, create the super-user login on the
primary controller. Then, at the LInux command line on the primary controller, run
the
filesync -a <IP_address_of_LSP>
command.
To create a login:
1. Ask a customer representative for a login name and password that the customer would like
for the superuser login. If you are a business partner, you can also repeat this procedure to
add the dadmin login.
Note:
Note:
Make sure the customer can change this login, its password, or its permissions
later.