Lucent Technologies LambdaUnite, Руководство по установке, Страница: 467 / 628

Required equipment
Prior to performing this task, the following equipment must be available:
1. WaveStar
®
CIT PC
2. CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4, Figure
4-48, “CIT connection (LAN crossed)” (p. 4-74) )
3. SDH/SONET analyzer
The required transmission rate depends on the optical circuit packs used within the
ring. The optical circuit pack with the lowest transmission rate determines the
transmission rate which should be used for the test. For example, if OP2G5, OP10
and OP40 circuit packs are used, an STM-16/OC-48 transmission signal is required.
4. ESD Wrist Strap.
Prerequisites
Prior to performing this task, you must have done the following:
1. Established the fiber connections (see section “Connecting the fiber cables”
(p. 10-4) ).
2. Configured the DCC channels of all used MS-SPRing/BLSR ports correctly (see
section “Provision DCC” (p. 10-12) ).
3. Logged in to WaveStar
®
CIT as Super User (see chapter 5, section “Starting the
WaveStar
®
CIT application” (p. 5-18) ) if WaveStar
®
CIT User Login has been
enabled during WaveStar
®
CIT installation.
Network establishment and testing 4-fiber MS-SPRing/BLSR test setup
.................................................................................................................................................................................................................................
365-374-187
Issue 1, December 2005 Lucent Technologies - Proprietary
See notice on first page
10-37