Lucent Technologies LambdaUnite, Руководство по установке, Страница: 448 / 628

Line timing test setup
.................................................................................................................................................................................................................................
Overview
This section provides the information needed to set up the line timing test (see section
“Line timing test” (p. 10-51) ).
Safety
CAUTION
ESD hazard
Electronic components can be destroyed by electrostatic discharge.
Always observe the ESD instructions (cf. “Electrostatic discharge” (p. 1-20) ).
Required equipment
Prior to performing this task, the following equipment must be available:
1. WaveStar
®
CIT PC
2. CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4, Figure
4-48, “CIT connection (LAN crossed)” (p. 4-74) )
3. ESD Wrist Strap.
Prerequisites
Prior to performing this task, you must have done the following:
1. Configured the DCC channels of all used optical ports correctly (see section
“Provision DCC” (p. 10-12) ).
2. Selected the correct synchronization system mode (SDH or SONET) (see chapter 7,
section “System parameters” (p. 7-16) ).
3. Logged in to WaveStar
®
CIT as Super User (see chapter 5, section “Starting the
WaveStar
®
CIT application” (p. 5-18) ) if WaveStar
®
CIT User Login has been
enabled during WaveStar
®
CIT installation.
4. Connected two external clocks with 2-MHz or 2 Mbit/s (SDH) or DS1 (SONET)
signals to NE-A.
Network establishment and testing
.................................................................................................................................................................................................................................
10-18 Lucent Technologies - Proprietary
See notice on first page
365-374-187
Issue 1, December 2005