BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 93 / 398

Learning Advanced Features
81
block at startup, the inverter will operate in the reverse direction even if it was running in the
forward direction in local operation mode before the reset.
•
Digital source commands: all command sources except terminal block command sources (which
are analog sources) are digital command sources that include the keypad, LCD keypad, and
communication sources. The inverter stops operation when switching to remote operation mode,
and then starts operation when the next command is given.
Use local/remote operation mode switching only when it is necessary. Improper mode switching will
result in interruption of the inverter’s operation.
Forward or Reverse Run Prevention
The rotation direction of motors can be configured to prevent motors from running in either
direction. If Ad.09 is set to 2 Reverse Prev, pressing the [REV] key on the LCD keypad will cause the
motor to decelerate to 0Hz and stop. The inverter will remain on.
Group Code Name LCD Display Parameter Setting Setting Range Unit
Ad 09
Run prevention
options
Run Prevent
0 None
0–2 - 1 Forward Prev
2 Reverse Prev
Forward/Reverse Run Prevention Setting Details
Code Description
Ad.09 Run Prevent
Choose a direction to prevent.
Setting Description
0 None Do not set run prevention.
1 Forward Prev Set forward run prevention.
2 Reverse Prev Set reverse run prevention.
Power-on Run
The power-on Run command can be set to start inverter operation after powering up. To enable
power-on run set the drv (command source) code to 1(Fx/Rx-1) or 2 (Fx/Rx-2) in the Operation
group. The digital input must be active (closed) during power up.
Group Code Name LCD Display
Parameter
Setting Setting
Range
Unit
Operation drv
Command
source Cmd
Source* 1,
2 Fx/Rx-1 or
Fx/Rx-2
0–5 -