BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 115 / 398

Learning Advanced Features
103
2nd Operation Mode Setting Details
Code Description
bA.01 Cmd 2nd Src
bA.02 Freq 2nd Src
When the digital input set to 2
nd
source is activated, the operating mode is
performed using the set values from bA.01 and BA.02 instead of the set values
from the drv and Frq codes in the Operation group.
The 2nd command source settings cannot be changed while operating with the 1
st
command source (Main Source).
•
When setting the digital input terminal to the 2
nd
command source (2nd Source), if the digital
input is active (On), operation will be from the 2
nd
command. Before closing the input to the
digital input terminal, ensure that the 2
nd
command is correctly set. Note that if the deceleration
time is too short or inertia of the load is too high, an overvoltage fault may occur.
•
Depending on the parameter settings, the inverter may stop operating when you switch the
command modes.
Multi-function Input Terminal Control
The functioning of the digital inputs can be configured to add filter time constants (time delays) and
NO or NC activation to each terminal individually.
Group Code Name LCD Display Parameter Setting Setting Range Unit
In
84 Multi-function input
terminal On filter
Selection DI Delay Sel 0 0000* 0 0000 ~ 1 1111
85 Multi-function input
terminal On filter DI On Delay 10
0
–
10000
ms
86 Multi-function input
terminal Off filter DI Off Delay 3
0
–
10000
ms
87 Multi-function input
terminal selection DI NC/NO Sel 0 0000* - -
90 Multi-function input
terminal status DI Status 0 0000* - -
* Displayed as on the keypad.
Multi-function Input Terminal Control Setting Details
Code Description
In.84 DI Delay Sel
Select whether or not to activate the time values
set at In.85 and In.86. If not activated (0 0000),
the time values are set to the default values at
In.85 and In.86. If activated, the set time values at