BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 77 / 398

Learning Advanced Features
65
Code Description
[V1 Filter ]
In.08 V1 Volt x1
In.09 V1 Perc y1
In.10 V1 Volt x2
In.11 V1 Perc y2
These parameters are used to configure the gradient level and offset values
of the Output Frequency, based on the Input Voltage.
[In.08 Volt x1 (min. volts), In.09 V1 Perc Y1, (min. % speed)]
[In.10 Volt y1, (max. volts), In.11 V1 Perc y2 (max. % speed)]
In.16 V1 Inverting
Inverts the direction of rotation. Set this code to 1 (Yes) if you need the
motor to run in the opposite direction from the existing rotation.
In.17.V1 Quantizing
Quantizing may be used when the noise level is high in the analog input (V1
terminal) signal.
Quantizing is useful when you are operating a noise-sensitive system,
because it suppresses any signal noise. However, quantizing will diminish
system sensitivity (resultant power of the output frequency will decrease
based on the analog input).
You can also turn on the low-pass filter using code In.07 to reduce the noise,
but increasing the value will reduce responsiveness and may cause
pulsations (ripples) in the output frequency.
100%
63%
V1 Filter(t)
V1 input from
external source
Frequency
V1
In.10 In.08
In.09
In.11
Frequency reference
input