BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 66 / 398

Learning Advanced Features
54
Step Instruction Keypad Display
7
Press the [
▲
] key.
To move to the Frq (Frequency reference source) code.
8
Press the [ENT] key.
The Frq code in the Operation group is set to 0 (Keypad).
9
Press the [
▲
] key to change it to 2 (Potentiometer), and
then press the [ENT] key.
The new parameter value will flash.
10
Press the [ENT] key once again.
The Frq code is displayed again. The frequency input has
been configured for potentiometer.
11
Press the [
▼
] key 4 times.
Returns to the first code of the Operation group (0.00).
From here frequency setting values can be monitored.
12
Adjust the potentiometer to verify the frequency
reference changes. The frequency reference will
change eventhough the drive is not running yet.
-
13
Press the [RUN] key on the keypad.
The FWD indicator light comes on steady. The RUN
indicator light flashes as the drive accelerates from 0 Hz.
to the frequency reference. When the drive frequency
is reached, the RUN indicator light becomes steady (not
flashing).
14
When the frequency reaches the reference (10Hz), press
the [STOP/RESET] key on the keypad.
The RUN indicator light flashes again and the
decelerating frequency is displayed. When the frequency
reaches 0Hz, the RUN and FWD indicator lights turn off,
and the frequency reference is displayed again.
[Wiring Diagram] [Operation Pattern]
SET
RUN
FWD
REV
10.00
SET
RUN
FWD
REV
10.00
Frequency
key
key
frq
0
‘2’
frq
0.00