BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 63 / 398

Learning Advanced Features
51
Frequency Setting (Keypad) and Operation (via Terminal Input)
Step Instruction Keypad Display
1 Turn on the inverter. -
2
Ensure that the first code of the Operation group is selected,
and code 0.00 (Command Frequency) is displayed, then press
the [ENT] key.
The first digit on the right will flash.
3
Press the [
◀
] key 3 times to go to the tens place.
The number ‘0’ at the tens place will flash.
4
Press the [
▲
] key to change it to 1, and then press the [ENT]
key.
The parameter value (10.00) will flash.
5
Press the [ENT] key once again to save changes.
A change of reference frequency to 10.00 Hz has been
completed.
6
Refer to the wiring diagram at the bottom of the table, and
close the switch between the P1 (FX) and CM terminals.
The FWD indicator light comes on steady. The RUN indicator
light flashes as the drive accelerates from 0 Hz. to 10 Hz.
When the drive frequency of 10 Hz. is reached, the RUN
indicator light becomes steady (not flashing).
7
When the frequency reference is reached (10Hz), open the
switch between the P1 (FX) and CM terminals.
The RUN indicator light flashes again and the decelerating
frequency is displayed. When the frequency reaches 0Hz, the
RUN and FWD indicator lights turn off, and the frequency
reference (10.00Hz) is displayed again.
SET
RUN
FWD
REV
10.00
SET
RUN
FWD
REV
10.00
0.0’0’
‘0’0.00
’10.00’
10.00