BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 220 / 398

Learning Advanced Features
208
Operation State Monitor Setting Details
Code Description
CNF-20
AnyTime
Para
Select items to display on the top-right side of the LCD keypad screen. Choose the
parameter settings based on the information to be displayed. Codes CNF-20–23 share
the same setting options as listed in the table below.
Setting Function
0 Frequency During operation, displays the actual output
frequency (Hz). When stopped, displays the
reference frequency.
1 Speed During operation, displays the actual operating
speed (rpm). When stopped, displays the set speed
(rpm).
2 Output Current Displays output current.
3 Output Voltage Displays output voltage.
4 Output Power Displays output power.
5 WHour Counter Display inverter power consumption. See Note
below on Inverter Power Consumption.
6 DCLink Voltage Displays DC link voltage within the inverter.
7 DI Status Displays input terminal status of the terminal
block. Starting from the right, displays P1
–
P8.
8 DO Status Displays output terminal status of the terminal
block. Starting from the right, Relay1, Relay2, and
Q1.
9 V1 Monitor[V] Displays the input voltage at terminal V1 (V).
10 V1 Monitor[%]
Displays the input voltage at terminal V1 as a
percentage. If -10V, 0V, +10V is measured, -
100%, 0%, 100% will be displayed.
13 V2 Monitor[V] Displays the input voltage at terminal V2 (V).
14 V2 Monitor[%] Displays the input voltage at terminal V2 as a
percentage.
15 I2 Monitor[mA] Displays the input current at terminal I2 (mA).
16 I2 Monitor[%] Displays the input current at terminal I2 as a
percentage.
17 PID Output Displays output of PID controller.
18 PID Ref Value Displays the reference (setpoint) value of the PID
controller.
19 PID Fdb Value Displays the feedback value of the PID controller.
20 Torque If the torque reference command mode (DRV-08)
is set to a value other than keypad (0 or 1), the
torque reference value is displayed.
21 Torque Limit If torque limit setting (Cn.53) is set to a value other
than keypad (0 or 1), the torque limit value is
displayed.