BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 4 / 398

Quick Reference Table
iv
inverter. Allowing foreign objects inside the inverter may cause the inverter to malfunction or
result in a fire
.
•
Do not operate the inverter with wet hands. Doing so may result in electric shock.
•
Check the information about the protection level for the circuits and devices.
The following connection terminals and devices are the Electrical Protection level 0 per IEC -
61140. This means that the circuit protection level depends on the basic insulation. If there is no
basic insulation this may cause electric shock. When installing or wiring the connection terminals
and devices, take the same protective action as with the power wire.
- Multi-function Input: P1-P5, CM
- Analog Frequency Input: VR, V1, I2, TI
- Safety Function: SA, SB, SC
- Analog Output: AO, TO
- Contact: Q1, EG, 24, A1, B1, C1, S+, S-, SG
- Fan
•
The protection level of this equipment (inverter) is the Electrical Protection level I.
•
Do not modify the interior workings of the inverter. Doing so will void the warranty.
•
The inverter is designed for 3-phase motor operation. Do not use the inverter to operate a single
phase motor.
•
Do not place heavy objects on top of electric cables. Doing so may damage the cable and
result in an electric shock.
Note – Short Circuit Current Rating, SCCR
Maximum allowed prospective short-circuit current at the input power connection is defined in IEC
60439-1 as 100 kA. Depending on the selected MCCB, the “S” Series inverter is suitable for use in
circuits capable of delivering a maximum of 100 kA RMS symmetrical amperes when protected by a
100 kaic rated breaker or fuses.