BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 89 / 398

Learning Advanced Features
77
Command Source Configuration
The start and stop commands can come from various sources. Input devices available to select
include keypad, digital input terminals (Px), RS-485 communication and field bus adapter. If
UserSeqLink is selected, the common area can be linked with user sequence output and can be
used as command.
Group Code Name LCD Display Parameter Setting
Setting
Range
Unit
Operation drv
Command
Source Cmd
Source*
0 Keypad
0
–
5 -
1 Fx/Rx-1
2 Fx/Rx-2
3 Int 485
4 Field Bus
5 UserSeqLink
* Displayed under DRV-06 on the LCD keypad.
The Keypad as a Command Input Device
The keypad can be selected as the start/stop source for the inverter. This is configured by setting
the drv (command source) code to 0 (Keypad). Pressing the [RUN] key on the keypad starts the
inverter and the [STOP/RESET] key stops it.
group Code Name LCD Display Parameter Setting
Setting
Range
Unit
Operation
drv
Command
source Cmd
Source*
0 KeyPad
0
–
5
-
* Displayed under DRV-06 on the LCD keypad.
Terminal Block as a Command Input Device (Fwd/Rev Run
Commands)
The digital input terminals can be selected as the start/stop command source. This is configured by
setting the drv (command source) code in the Operation group to 1(Fx/Rx). Select 2 terminals for
the forward and reverse operations, codes In.65
–
69 for P1
–
P5 to 1(Fx) and 2(Rx) respectively. This
application also enables both terminals to be turned on or off at the same time, constituting a stop
command that will cause the inverter to stop operation.
Group Code Name LCD Display
Parameter
Setting Setting
Range
Unit
Operation
drv Command
source Cmd
Source* 1 Fx/Rx-1
0
–
5 -
In
65
–
71
Px terminal
configuration Px
Define(Px:
P1– P5) 1 Fx
0
–
54 -
2 Rx
* Displayed under DRV-06 on the LCD keypad.