BENSHAW Rsi S Series, Инструкция по эксплуатации

Страница: 156 / 398

Learning Advanced Features
144
Auto Tuning Default Parameter Setting
Motor Capacity
(kW) Rated
Current (A) No-load
Current
(A) Rated Slip
Frequency(Hz) Stator
Resistance(
Ω
Ω Ω
Ω )
Leakage
Inductance (mH)
200V 0.2 1.1 0.8 3.33 14.0 40.4
0.4 2.4 1.4 3.33 6.70 26.9
0.75 3.4 1.7 3.00 2.600 17.94
1.5 6.4 2.6 2.67 1.170 9.29
2.2 8.6 3.3 2.33 0.840 6.63
3.7 13.8 5.0 2.33 0.500 4.48
5.5 21.0 7.1 1.50 0.314 3.19
7.5 28.2 9.3 1.33 0.169 2.844
11 40.0 12.4 1.00 0.120 1.488
15 53.6 15.5 1.00 0.084 1.118
18.5 65.6 19.0 1.00 0.068 0.819
22 76.8 21.5 1.00 0.056 0.948
400V 0.2 0.7 0.5 3.33 28.00 121.2
0.4 1.4 0.8 3.33 14.0 80.8
0.75 2.0 1.0 3.00 7.81 53.9
1.5 3.7 1.5 2.67 3.52 27.9
2.2 5.0 1.9 2.33 2.520 19.95
3.7 8.0 2.9 2.33 1.500 13.45
5.5 12.1 4.1 1.50 0.940 9.62
7.5 16.3 5.4 1.33 0.520 8.53
11 23.2 7.2 1.00 0.360 4.48
15 31.0 9.0 1.00 0.250 3.38
18.5 38.0 11.0 1.00 0.168 2.457
22 44.5 12.5 1.00 0.168 2.844
*When Dr.09 (Control Mode) is set to 6 (PM Sensorless), auto tuning will configure the rated current
and the stator resistor values by default.
Auto Tuning Parameter Setting Details
Code Description
bA.20 Auto Tuning
Select an auto tuning type then press the [ENT] key to run the auto tuning.
Setting Function
0 None Auto tuning function is not enabled. Note: when
you select one of the auto tuning options below
and run it, this parameter value will revert back to
“0” when the auto tuning is complete.
1 All (rotating
type) Measures all motor parameters, including stator
resistance (Rs), stator inductance (Lsigma), no-
load current (Noload Curr), rotor time constant