![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745380.webp)
Reconditioning (cont’d)
Bushing Removal (cont’d)
77 - 2
Section E
Hydraulics
9803/6410
Section E
77 - 2
Issue 1
Hydraulic Rams
Gradually insert the chuck assembly into the cylinder
head until its blade end reaches the bushing end.
1
Insert the chuck assembly into the cylinder head,
taking care that parts of the blade do not damage
the inner circumferential surface.
2
Be careful that the blade does not jump out from the
bushing end surface.
1
Fit the Allen wrench into the chuck assembly adjuster
head and at the same time insert the lever into the
chuck assembly rear hole.
2
Tighten enough so that when the cylinder head is
lifted, the jig will not fall off.
Note:
Tightening torque less than 5 kgf m (36.16 lbf ft) is
sufficient.
Move the cylinder head and chuck assembly to the press
bench, gripping the assembly as shown.
3
Setting the chuck assembly
4
Temporary tightening
JS02310
Summary of Contents for JS130
