![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745076.webp)
1 - 3
Direct Glazing (cont'd)
Removing the Broken Glass and Old Sealant (cont'd)
b
Cut-out Knife
F
. The cut-out knife can be used as a
left handed or right handed tool. For the knife and its
replaceable blades, refer to
Service Tools
, Section
1.
(i) Insert the knife blade into the sealant.
(ii) Make sure that the blade of the knife is against
the glass as shown at
G
.
(iii) Use the 'pull-handle' to pull the knife along and
cut out the old s ealant.
c
Craft Knife
H
. The blades are replaceable.
(i) Insert the knife blade into the sealant.
(ii) Pull the knife along and cut out the old sealant.
Note:
There are other tools available to cut out the old
sealant. For example, there is a long handle type craft knife
to give extended reach. Refer to
Service Tools,
Section 1,
for details of this and any other tools.
4
Toughened glass - remove the cut off sealant and all
remaining particles of shattered glass.
5
If necessary, trim off the remaining old sealant to leave
approximately 1 to 2 mm on the upright face of the cab
frame aperture, as shown at
J
.
6
Apply a coat of 'Black Primer 206J' to the paintwork if:
a
Paintwork was damaged or scratched during the
glass/sealant removal procedures.
b
The old sealant was inadvertently cut back to the
cab frame during the glass/sealant removal
procedures.
Preparing the Cab Frame Aperture
1
If damp or wet, dry the aperture area using a hot air gun
(sourced locally).
2
Use 'Active Wipe 205' to thoroughly clean and 'prime'
the trimmed sealant. Use a lint free cloth to apply the
'Active Wipe 205', allow 5 minutes flash off (drying)
time.
Note:
Do not use any other type of cleaning fluids, otherwise
they may be absorbed into the old sealant and ultimately
prevent the new glass from bonding.
Section B
Body & Framework
9803/6410
Section B
1 - 3
Issue 1
Cab
S186370
S189890
S189900
F
G
H
J
Summary of Contents for JS130
