![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745249.webp)
14 - 16
Section E
Hydraulics
9803/6410
Section E
14 - 16
Issue 1
Hydraulic Pump/Regulator
11
Using a swash plate levelling jig (see
Service Tools
,
Section 1), adjust swash plate
7
so that it is parallel
with the outer face of pump housing
1
, by ensuring the
same height
A
on the left and the right
12
Install two guide rods (see
Special Tools
, Section 1)
into opposite threaded holes in the pump housing
flange.
Assembly (cont’d)
13
a
Insert two pins
64
into flange
2
, then fit the outer
race of bearing
13
into the flange.
b
Fit ‘O’-ring
78
into the flange.
c
Insert pin
62
into pump housing
1
and then
assemble flange
2
onto the housing along the guide
rods fitted at step 12.
d
Install four socket head bolts
73
into the vacant
mounting holes. Remove the two guide rods and
insert the remaining two bolts
73
. Tighten the bolts
evenly to a torque of 129 Nm (95 lbf ft, 13.1 kgf m).
14
Lay the pump housing on its side and repeat steps 1, 2
and 3 at the rear end of the housing. Fit the cylinder
block assembly on the spline of shaft
5
.
Using suitable blocks to allow the shaft to clear the
work surface, position the pump housing on the bench,
rear end uppermost.
JS00110
Summary of Contents for JS130
