![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745429.webp)
92 - 15
30
Insert plug
26
with an 8 mm Allen key and tighten to
torque of 39.32 Nm (29 lbf ft).
Fill with gear oil through the filler port.
Note:
Fill the hydraulic motor case with hydraulic oil before
connecting the piping to the drain port.
See
Fluids and Lubricants
, Section 3, for type and quantity
of oil.
31
Apply grease (type and capacity is given in
Fluids and
Lubricants
).
Note:
Bleed air in the chamber from the air bleed port before
filling with grease, as a build-up of internal pressure can
damage the oil seal.
After the unit is filled, run it for around 10-15 minutes at zero
load, and at low speed and verify that there is no abnormal
noise or vibration. Gradually bring the system into high
speed and loaded operation.
Section E
Hydraulics
9803/6410
Section E
92 - 15
Issue 1
Slew Motor
Motor Assembly/Cylinder Assembly
Assembly (cont’d)
Summary of Contents for JS130
