![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745248.webp)
14 -1 5
Section E
Hydraulics
9803/6410
Section E
14 - 15
Issue 1
Hydraulic Pump/Regulator
7
Using suitable blocks to allow the shaft to clear the
work surface, position the pump housing on the bench,
front end uppermost.
8
a
Fit the two guide assemblies
21
and slide metal
22
to swash plate
7
.
Note:
The hole in slide metal
22
is not central. Install with
the hole furthest from the pistons.
b
Assemble swash plate
7
into the pump housing.
Note:
Position regulator piston
23
with the groove for slide
metal
22
in the centre and locate the two during assembly.
Assembly (cont’d)
9
Using a suitable tool (see
Service Tools
, Section 1) and
a press, fit bearing
3
onto shaft
5
.
Note:
This job can be carried out by drifting the bearing into
place, taking care not to scratch or damage the bearing, the
shaft or any other parts.
10
Fit bearing cage/rollers
14
on swash plate
7
. Set guide
assembly
21
in the cut-out of the bearing cage,
standing upright.
Summary of Contents for JS130
