![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745047.webp)
5 - 7
Cleaning/Changing the Suction Strainer
1
Prepare the Machine
Position the machine on level ground.
Stop the engine. Remove the starter key.
2
Locate the Suction Strainer
3
Release Tank Pressure
See
Releasing Tank Pressure.
4
Remove the suction Strainer
a
Remove the retaining bolts
A
and washers
D
, lift off
cover plate
B.
b
Remove the suction strainer
C
and clean with a
suitable solvent or, if renewing discard.
5
Fit the Suction Strainer
Fitting is a reversal of removal.
6
Check the Hydraulic fluid Level
See
Checking the Fluid Level
.
7
Seal the System
Refit the cover plate
B
together with its 'O'-ring.
Note:
Check the 'O'-ring, if it is worn or damaged replace it
with a new one and secure with bolts
A
and washers
B.
Section 3
Routine Maintenance
9803/6410
Section 3
5 -7
Issue 1
Hydraulics (continued)
A
D
B
C
Summary of Contents for JS130
