![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745272.webp)
18 - 19
Regulator (cont’d)
Dismantling and Assembly (cont’d)
Assembly
Before assembling:
a
Thoroughly clean all components with clean hydraulic oil
and dry with compressed air.
b
Apply clean hydraulic oil to all sliding surfaces, bearings,
etc.
c
Renew any damaged components.
d
Renew all O-rings and other seals.
1
Insert compensating rod
42
into hole
B
of regulator
body
1
.
2
Locate pin
37A
in lever
36
in the groove of
compensating rod
42
. Locate lever
36
on pin
37
in
regulator body
1
.
3
Fit spool
39
and sleeve
26
into hole
A
of regulator body
1
. Check that the spool and the sleeve slide smoothly in
the body without binding. Check the orientation of the
spool with respect to feedback lever
35
(see right).
4
Install feedback lever
35
, orientating it as shown right
and aligning its pin hole with that of spool
39
. Insert pin
34
.
5
Insert pilot piston
38
into hole
C
of regulator body
1
.
Check that the piston slides freely without binding.
Section E
Hydraulics
9803/6410
Section E
18 - 19
Issue 1
Hydraulic Pump/Regulator JS130, JS160
Spool
Feedback Lever
Lever(1)side
Lever(2)side
(Fulcrum plug of
adjusting plug side
379480
379470
379480
35
32
39
36
35
Summary of Contents for JS130
