![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745214.webp)
4 - 2
Pressure Measurement
Measurement
Part Name
bar (lb/in
2
)
Method
Port
Main Relief
Standard: 314 - 320 bar (4554 - 4641 lb/in
2
)
Dipper Relief
G1(G2)
Power Boost: 343 - 350 bar (4975 - 5076 lb/in
2
)
Boom Port Relief
Raise
358 - 365 bar (5192 - 5294 lb/in
2
)
Boom Up Relief
G2
Lower
295 - 305 bar (4278 - 4423 lb/in
2
)
Boom down Relief
G2
Bucket Port Relief
Open/Close
358 - 365 bar (5192 - 5294 lb/in
2
)
Bucket Relief
G2
Dipper Port Relief
Out/In
358 - 365 bar (5192 - 5294 lb/in
2
)
Dipper Relief
G1
Swing Port Relief
Left/Right
275 - 285 bar (3988 - 4133 lb/in
2
)
Swing Relief
G1
Pilot Relief
37 - 43 bar (536 - 624 lb/in
2
)
Lever Neutral
G3
Accumulator
15 ± 5 bar (217 ± 72.5 lb/in
2
)
G3
Track Motor Relief
338 - 348 bar (4902 - 5047 lb/in
2
)
G1(G2)
Section E
Hydraulics
9803/6410
Section E
4 - 2
Issue 1
Pressure Testing
Pressure Testing - General
Confirmation of the oil Temperature
Confirm the oil temperature is between 45° - 55° C using the
self check function. If the temperature is low use the following
warm-up procedure.
Warming-up Procedure
1
Turn the Throttle Control to mid-range and make sure the
Work Mode Selection Switch is set to S.
2
Press the One Touch Idle Switch.
3
Run the engine until the Coolant Temperature gauge
reads within the normal (green) range.
4
Set the Servo Isolator Switch to ON to enable the
hydraulic servo controls to be operated.
5
Operate the bucket control slowly until it reaches one end
of its travel and leave it there for 30 seconds.
6
Operate the bucket control slowly to the other end of its
travel and leave it there for 30 seconds.
7
Repeat steps 5 and 6 for 10 minutes to warm up the
hydraulic circuit.
8
Now operate the excavating controls three to five times in
each direction to distribute warm hydraulic oil around the
system.
Summary of Contents for JS130
