379380
3
2
1
379390
18 - 15
Regulator
Dismantling and Assembly
The working environment must be clean and the workbench
covered with a cloth or rubber sheet to prevent damage to
the components.
The item numbers called up in the following procedures
correspond with those in the exploded view opposite.
Dismantling
Before dismantling, remove dust, rust, etc. using clean
hydraulic oil.
Retain all washers, snap rings etc. for later re-use. O-rings
should be renewed.
1
If not already done, separate the regulator
1
from the
pump casing by removing socket head screws
2
and
3
(2 off each).
2
Remove the four socket head screws
5
and lift off cover
6
complete with adjusters
7
/
8
, adjusting screw
9
, two
locking nuts
10
, mounting nut
11
and adjusting ring
12
.
Do not interfere with the settings of any of these
components as this could alter the pre-set flow settings.
Section E
Hydraulics
9803/6410
Section E
18 - 15
Issue 1
Hydraulic Pump/Regulator JS130, JS160
6
5
Summary of Contents for JS130
