![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745052.webp)
Key
A
filler/level plug
B
drain plug
C
filler plug
D
level plug
6 - 1
Note:
There are two alternative configurations of filler, level
and drain plugs as shown in figures
X
and
Y
. The following
text covers both configurations.
Checking the Track Gearbox Oil Level
1
Prepare the Machine
Position the machine on level ground with the level and
drain plugs on a perpendicular line, with the level plug
uppermost.
2
Check the Level on One Side
Clean the area around filler/level plug
A
or filler plug
C
/level plug
D
and remove one or both plugs. Oil
should run from plug
A
or
D
. Top up through plug
A
or
C
if necessary. (See
Fluids and Capacities
for oil
types).
3
Clean and Refit the Plug(s)
Make sure they are tight.
4
Check the Level on the Other Side
Repeat steps 1 to 3.
Changing the Track Gearbox Oil
1
Prepare the Machine
See
Checking Track Gearbox Oil Leve
l.
2
Drain the Oil on One Side
a
Place a container below the drain plug to catch the
oil. The container must be large enough to hold the
maximum gearbox capacity (see
Fluids and
Capacities
).
!
!
CAUTION
Oil will gush from the hole when the drain plug is
removed. Keep to one side when you remove the drain
plug.
2-3-4-2
b
Remove filler/level plug
A
or filler plug
C
and drain
plug
B
. Allow the oil to drain out.
c
Wipe the plugs clean. Make sure you remove all
metal particles.
d
Wrap seal tape on the drain plug and refit.
3
Fill with New Oil
See
Lubricants and Capacities
for oil type and
volume.
a
Pour new oil through filler/level plug
A
or filler plug
C
until oil runs out of plug
A
or
D
.
b
Clean and wrap seal tape around the plugs. Tightly
refit filler/level plug
A
or filler plug
C
/level plug
D
.
4
Change the Oil on the Other Side
Repeat steps
1
to
3
.
5
Check for Leaks
Run the machine, operate the tracking controls and
t
h
e
n
make sure there are no leaks.
Section 3
Routine Maintenance
9803/6410
Section 3
6 - 1
Issue 1
Transmission
Summary of Contents for JS130
