![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745499.webp)
Assembly (cont’d)
When Assembling (cont’d)
8
Tighten the plug and bolts to the torques indicated
below:
Adjustments
Determining the Thickness of Distance Piece 12
This procedure must be carried out if any of the following
components have been renewed: hub 1, spindle 2, ring gear
4, coupling gear 8, pin 17, bearings 24 or parallel pins 27.
1
Install the distance piece clearance gauge B (see
Service Tools, Section 1) in spindle 2 in place of
distance piece 12.
2
Lightly tighten three evenly spaced bolts 35.
3
Measure dimension ‘A’ with depth micrometer as
shown.
4
Measure dimension ‘C’ of the assembled coupling gear
8.
5
Clearance X = A - B, where ‘B’ is the dimension of
gauge B.
Calculate the optimum thickness ‘T’ of distance piece
12 as follows:
T = C + X ± 0.1 mm
10 - 8
Section F
Transmission
9803/6410
Section F
10 - 8
Issue 1
Reduction Gear - JS160
JS00660
Torques
Part
Nm
lbf ft
kgf m
Plug 30
59 ± 20
43.4 ± 14.5
6 ± 2
Bolt 32
102 ± 15.7
75.2 ± 11.6
10.4 ± 1.6
Bolt 35
348 ± 54
257 ± 40
35 ± 5.5
Summary of Contents for JS130
