![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745192.webp)
9 - 12
Section C
Electrics
9803/6410
Section C
9 - 12
Issue 1
Fault Finding
Fault Diagnosis (continued)
Battery Charging, Problem No 9
Note:
Message does not go out.
Prior Confirmation
Items
1
The
"MODE"
of the mode display is not flashing.
Troubleshoot
Cause
Remedy
Defective WR
wiring between CN2
Repair WR
and CNC
Clean CN2
Bad connection of
connector
CN2 or controller
terminal or
defect
replace
controller.
Replace
Alternator defect
alternator
Repair WR
Breakage of WR
wiring
wiring between CNC
between
and alternator or
CNC and
bad connection of
alternator
alternator spade
or clean
terminal
spade
terminal.
Does hour meter
operate?
YES
YES
YES
NO
NO
NO
Remove CN2 connector and
measure voltage between
female side terminal WR and
ground?
Is it more than 10V?
Remove spade terminal of
alternator R and measure
voltage between female side and
ground.
Is it more than 10V?
Remove CNC connector and
measure voltage between
male side terminal WR and
ground?
Is it more than 10V?
YES
NO
Summary of Contents for JS130
