jcb JS130, Service Manual

Page: 174 / 533

8 - 2
Self Test Function (continued)
Each item is changed with the Self Check Switches located
on the right hand side of the back-up switch.
There are four Self Check Switches
1 The CHANGE switch which is used to change to the
self-check mode.
2 PATTERN switch which changes from the service
check function to the setting function.
3 SELECT switch which moves from item to item.
4 RESET which locks the set values into the controller.
This set of four switches is usually covered so that the
operator cannot accidentally operate them.
Checking Methods
When the engine key is inserted and turned to the ON
position, the "STANDARD MODE" is displayed in the
Message display section, and S is displayed in the WORK
mode section and theTIME is displayed in the CLOCK
display.
When the CHANGE switch is pressed the Model designation
is displayed:
121 = JS130
151 = JS160
Section C Electrics
9803/6410
Section C
8 - 2
Issue 2*
Self Test
BACK UP MANUAL THROTTLE
UP
H M
DOWN
ADJUST/CLOCK
Change
Select Reset
Pattern
Self-check
Change
Select Reset
Pattern
Self-check
Change
Select Reset
Pattern
Self-check
Message
WORK MODE
MODE
CLOCK
S : STANDARD MODE
Change
Self-check
Message
WORK MODE
MODE
CLOCK
CH : MN
JS10940
*
*
Cover installation
screws x 2