![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745191.webp)
9 - 11
Section C
Electrics
9803/6410
Section C
9 - 11
Issue 1
Fault Finding
Fault Diagnosis (continued)
Fluid Overheating, water, oil, Problem No 8 (continued)
Note:
Message does not go out even if the actual Temperature is below the following:-
Hydraulic Oil Temperature 84°C
Engine Coolant Temperature 92°C
Troubleshoot
Cause
Remedy
Thermo switch
Replace
(oil) defect
switch
Defective Br
wiring between CNB
Repair Br
and thermo switch (oil)
wiring
Defective Br
wiring between CN3
Repair Br
and CNB
wiring.
Controller defect
Replace
controller
Thermo switch
Replace
(oil) defect
sensor.
Bad connection
Clean
of thermo sensor
sensor
(oil) connector
connector
terminal
Clean
Bad connection of
CNE
CNE
connector
terminal
Replace
Controller defect
controller
or bad connection
or clean
CN10
CN10
connector
terminal
Note:
When there is breakage in the wiring, the bar graph goes out completely.
Is thermo sensor (oil)
temperature abnormal
at self-check?
(comparison of actual
and indicated
temperature)
YES
YES
YES
NO
1. Oil temperature bar graph lit at 8 graduations.
Key switch
ON
Remove thermo sensor (oil)
connector and measure resistance
of sensor side.
Is it within the range of values in
separate chart?
(Refer to resistance values in
separate chart)
When thermo switch
(oil) connector is
removed, does
message go out?
When CNB connector
is removed, does
message go out?
When CN3 connector is
removed, does
message go out?
Remove CNE connector and
measure resistance between male
side terminal BrW and GR.
Is it within the range of values in
separate chart?
(Refer to resistance values in
separate chart)
Remove CN10 connector and
measure resistance between
female side terminal BrW and GR.
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES
Key switch
OFF
• Display oil
temperature with
self-check
• Measure actual
temperature
Summary of Contents for JS130
