![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745433.webp)
94 - 2
5
Dismantling of 2nd stage holder assembly.
Drive spring pins
75
into shaft
70
.
Note:
The spring pins cannot be reused.
!
WARNING
Metal Splinters
You can be injured by flying metal splinters when driving
metal pins in or out. Use a soft faced hammer or drift to
remove and fit metal pins. Always wear safety glasses.
INT-3-1-3
6
Support planetary gears
72
by hand and withdraw shaft
70
from holder
76
.
Section E
Hydraulics
9803/6410
Section E
94 - 2
Issue 1
Slew Motor
Reduction Gear
Dismantling (cont’d)
7
Ring gear removal
Remove ring gear
64
from gear case
58
. JCB High
Strength Gasketing is applied on the assembly to
prevent oil leaks from between the ring gear and gear
case. To remove ring gear
64
use the notch on gear
case
58
.
8
Removal of pinion gear assembly.
Remove snap ring
55
with a screwdriver using the
notch in the case for leverage.
Summary of Contents for JS130
