![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745053.webp)
6 - 2
Checking the Slew Gearbox Oil Level
1
Prepare the Machine
Position the machine on level ground. Stop the engine
and remove the starter key.
2
Locate the Slew Gearbox
See C
omponent Location Diagrams
at the end of this
section.
3
Check the Level
a
Remove the dipstick
A
, wipe it clean and re-fit.
b
Remove the dipstick again and check that the oil
level is within the range
B.
c
If necessary, top up through filler port
C
. (See
Lubricants and Capacities
for oil type).
4
Refit the Dipstick.
Changing the Slew Gearbox Oil
1
Prepare the Machine
Position the machine on level ground. Stop the engine
and remove the starter key.
2
Drain the Oil
a
Remove the drain plug
D
. Allow the oil to drain out.
b
Wipe the drain plug clean. Remove any metallic
particles.
c
Refit the drain plug. Make sure it is tight.
3
Fill with New Oil
See
Lubricants and Capacities
for oil type and
volume.
Fill with new oil through filler port
C
until it reaches the
full mark on the dipstick when settled. refit the dipstick.
4
Check for Leaks
Run the machine, operate the slew controls and make
sure there are no leaks.
Replenishing Slew Gearbox Grease
1
Prepare the Machine
Position the machine on level ground. Stop the engine
and remove the starter key.
2
Remove Air Bleed Plug E.
!
!
CAUTION
Failure to remove the bleed plug before adding grease
could damage the inner seal.
8-3-4-7
3
Fill Up with Grease
See
Lubricants and Capacities
for grease type.
Pump in grease through nipple
F
until the grease starts
to ooze from bleed plug
E
. Refit and tighten the bleed
plug.
Section 3
Routine Maintenance
9803/6410
Section 3
6 - 2
Issue 1
Transmission (continued)
JS130
JS160
E
F
F
E
Summary of Contents for JS130
