![background image](http://html1.mh-extra.com/html/jcb/js130/js130_service-manual_3610745457.webp)
6 - 4
Removal and Replacement (cont’d)
Replacement (cont’d)
4
a
Install the covers over the motor.
b
Check the amount of oil in the gearbox.
c
Bleed air from the motor (see
Motor Bleeding
).
d
If the traction motor has been dismantled and
serviced, carry out the functional tests detailed
under
Testing
later in this section.
e
Install the drive sprocket (see
Drive Sprocket
,
Replacement
, Section J).
f
Remove the wooden blocks.
g
Position the lower frame on the track.
h
Move the track link by reversing step 1 of
Removal
.
i
Clean the seal ring housings in the chain link. Insert
the seal rings and clamp into position.
j
Using a plastic hammer, tap the upper link down to
align holes.
Note:
As the links overlap, the seal rings will be held in
position. Remove ‘G’ clamps.
k
Insert the pointed guide pin from the inner face and
tap through its full length.
l
Position a suitable hydraulic press so that its ram
aligns with the guide pin.
m
Insert the master pin into its locating hole.
n
Slowly operate the hydraulic ram and press the
master pin into position.
o
Re-locate the track shoes and tighten the bolts (see
Checking Shoe Plate
,
Routine Maintenance
,
Section 3).
Section F
Transmission
9803/6410
Section F
6 - 4
Issue 1
Traction Motor/Reduction Gear
JS02800
JS02810
JS02820
Summary of Contents for JS130
